freetraveller wrote:
Hi Muzza,
Have the same stove and have had the same problem with the oven going out after 5 minutes or so.
Which way did you move the burner - to the right ?
freetraveller.....
If you look inside your oven to the back bottom you will see the burner, it is held in place with one small phillips head screw, remove this screw and lift the burner out (might require a bit of jiggling). You will notice that it is a kind of Z shape with the open, lower end being where the jet is located when assembled. The jet will be left behind still attached to the oven it won't come out with the burner.
You should then determine which way to elongate the burner retaining hole to give a bigger gap between jet and burner.
I must also stress that advice from a certified Gas fitter/person/manufacturer, should be obtained on this matter before you proceed.
The regulator delivery pressure was checked and found to be ok.
Muzza.